Luce PT-L6510E User Manual download pdf (Page 36)

Deleting User Mode

(e.g. Deleting the data of “USER1”)

1. Choose “USER MODE” on “OPTION2” and press

the “ENTER” button.

2. Choose “DELETE” using the or buttons.

3. Choose the address (USER1) you want to delete

data from using the or buttons and press the

“ENTER” button.

4. After recorgnizing the flashing of the address

display, press the “ENTER” button again to delete

the data of the address.

Registering/Deleting/

Displaying User Mode

(For RGB/YPBPR signals only)

Once adjustment settings are registered with User

Mode, they are automatically loaded each time the

projector is powered up. It is not necessary to readjust

settings at every power on.

Registering User Mode

(e.g. Registering positioning data with “USER1”)

1. Apply an input signal you want to register, and

then adjust the picture position, size, and others.

2. Choose “USER MODE” on “OPTION2” and press

the “ENTER” button.

3. Choose “USER1” using the or buttons and

press the “ENTER” button.

4. After recognizing the flashing of the USER1

address display, press the “ENTER” button again.

5. The above adjusted settings has been registered

with “USER1”. Similarly you can also register

settings with “USER2” or “USER3”.

SETTING UNIT ID

UNIT ID is used to set projector IDs when the user

wishes to control two or more projectors either

simultaneously or separately.

"ALL": The projectors can be simultaneously

controlled from any remote control regardless

of their ID settings.

"1": The projector can be controlled from the remote

control with its projector ID set to “1”.

"2": The projector can be controlled from the remote

control with its projector ID set to “2”.

"3": The projector can be controlled from the remote

control with its projector ID set to “3”.

Note

• Unit ID is set to “ALL” by default. Hence ID

number need not be set when only one

projector is used.

• If the projectors are given ID numbers, their

remote controls must be assigned the same

ID numbers, respectively.

• If the unit IDs of two or more projectors are

set to “ALL”, the user will not be able to

control them separately.

• The projector can be turned ON/OFF from

the remote control only if the projector ID is

set in the remote control. For the details of

projector ID setting, see page 15.

SET ID

ALL

USER MODE

ENTRY USER1

SELECT ADJ ESC

USER MODE

ENTRY USER1

DELETE USER1

SELECT ADJ ESC

OPTION 2 settings

Displaying User Mode

The User Mode can be displayed by following the

steps described in “SIGNAL MODE” on page 31.

Note

• The user address has “USER1” to “USER3”.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 49 50

Comments to this Manuals

No comments

Luce PT-L6510E User Manual Page 36

Comments to this Manuals